Some h.i.d. Help

[SLOMOGT]

hey whats up guys so i bought 2 sets of 55w hid kits from vvme and i was wondering if i need 2 sets of relay harness to power them up or should i just run them just the way they came? :help

[SEAN]

I would suggest using the relay harnesses from my past experiences with HID...HID's put a good strain on the electrical system and battery and the harnesses seem to help regulate everthing causing fewer problems in the end...

[ISMELLRICE]

hmm i dont know much about those from vvme but i ordered mine from ddm tuning and everything has been fine for about a month now...dont remember if mine are 55w though

[Rossim22]

I did not have a wire harness for mine and I just put them in a couple days ago. What the instructions leaves out is that since you use 9007 bulbs, you have a power plug. The plug has three outlets, but the ballast leaves only two, a pos and neg wire. My trouble was that I did not know which holes to put them in. Plus, once you put them in, they lock and cannot be taken out, so i had to cut and reconnect them after putting them in the proper spots.

This is what you need that is not supplied in HID instructions.
http://www.vvme.com/images/90049007.jpg

However, if you only use the single beam xenons, you will have no high beams, just low... which is pretty much brighter than the high beams lol.

[SLOMOGT]

thanks guys well i guess im just gona go ahead and buy the relay harness and do it the safe and easy way !